Blind Monk Instruments Navigator Manual page 12

To access the following pages on the Navigator, press the MENU button.
LOAD
Press the FUNC button to load the selected patch.
Line 1: Patch Bank - Banks A through O store sound patches. Bank P stores sequences
or chords, Bank Q loads a sequence based on the internal algorithms. Each time you
load one of the algorithms, a new and unique sequence is created. Each of the ten
algorithms is different.
Line 2: Patch Number - Each bank contains ten patches for a total of 150 sound
patches, 10 sequence or chord patches, and 10 sequence generators.
Line 3: Name - displays the name of the selected patch
Line 4: Voices - allows you to load a different sound patch into each of the four voices.
In unison or duo mode this allows for complex layering of sounds. When All is selected,
the sound is loaded into all four voices.
(Because of the synth's internal architecture, each voice will have the same filter
resonance level as well as the same LFO 1 sync setting, all other parameters are
independent between each voice).
SAVE
Press the FUNC button to store the current sound or sequence.
Line 1: Patch Bank: A through O are for sounds, and P is for saving sequences or
chords
Line 2: Patch Number - Selects the 10 different patches for each of the banks
Line 3: Name - Use the IV (Line 4) knob to control the arrow below the letter then use
the III (Line 3) knob to change the letter.
Line 4: Arrow - selects the letter to change
12