Blind Monk Instruments Navigator Manual page 11

Last Knob Turned
The last knob turned destination can control any parameter on the main menu.
To use this feature:
1. Make sure the LFO 1 destination is NOT set to "last knob turned"
2. Then adjust the parameter on any page of the main menu
3. Turn LFO 1 destination to "last knob turned"
TIP You can adjust start point of the modulation on the line you are changing.
Use the LFO 1 amount in combination with the start point to get the desired effect
LFO 2
Line 1: Shape of LFO 2
(square, triangle, saw, ramp, sample and hold)
LFO 2's sample and hold is triggered by LFO 1's speed
Line 2: Speed of LFO 2
Line 3: LFO 2 modulation destination
(filter cutoff, oscillator shape, oscillator 1 pitch, oscillator 2 pitch, rind modulation
level, LFO 3 speed, oscillator 1 octave, oscillator 2 octave, oscillator 2 harmonic
series)
LFO 3
Line 1: Shape of LFO 3
(square, triangle, saw, ramp, sample and hold)
LFO3's sample and hold is triggered by each incoming MIDI note / key press
Line 2: Speed of LFO 3
Line 3: LFO 3 modulation destination
(filter cutoff, oscillator shape, oscillator 1 pitch, oscillator 2 pitch, LFO 1 Speed,
oscillators 1 and 2 pitch, oscillator 1 octave, oscillator 2 octave, oscillator 2
harmonic series)
11