Overview Of The Components; Packaging Contents; Unpacking The Device; Notes On Use - Profi Cook PC-WKS 1119 Instruction Manual

- In staff kitchens in shops, offices and other commercial areas;
- By guests in hotels, motels and other accommodation facilities.
It is not intended for use in farm accommodation or Bed & Breakfast
establishments.
• The following symbols are on the product:
CAUTION:
Do not immerse the device into water for cleaning. Please follow
the instructions as stipulated in the chapter "Cleaning".

Overview of the Components

1 Spout
2 Contact area for closing the lid
3 Lid
4 Button for opening the lid
5 Handle
6 Water level indicator
7 On / Off switch
8 Base

Packaging Contents

1x Water kettle
1x Base

Unpacking the Device

1. Remove the device from its packaging.
2. Remove all packaging materials such as films, padding,
cable holders, and cardboard.
3. Check the packaging contents for completeness.
4. Check the device for any transport damage in order to
avoid hazards.
NOTE:
If there is any visible transport damage, contact your dealer
immediately. Do not operate the device if damaged!

Notes on Use

Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives
or ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
32
PC-WKS1119_IM
Electrical Connection
Check whether the electrical voltage that you intend to use is
the same as that of the appliance. Details are to be found on
the label on the base.
Connected Wattage
The total power consumption of this device can be up to
2200 W. With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is too
powerful.
Switching on / off
• Switching on:
Press the toggle switch downwards. The indicator light in
the switch lights up.
• Switching off:
Press the toggle switch upwards. The indicator light in the
switch goes off.

Use

NOTE:
Always use fresh water.
1. Place the appliance on a flat surface.
2. Press the button in the handle to open the kettle.
3. Then fill in the water (max. 1.7 Litre). You can read the
filling level on the water level indicator of the kettle.
4. Close the lid. Press down on the contact area (2) to close
the lid.
5. Place the kettle flush on the base.
6. Only connect the appliance to a properly installed safety
socket.
07.09.16