Table of Contents
Advertisement
I-E96-107-2N
Creating a QNX Hard Disk Partition
STEP 1
At the # prompt type:
install
QNX's hard disk installation screen is displayed.
This screen displays the QNX Technical support phone num-
ber and other miscellaneous warnings. If you require support,
call your nearest Elsag Bailey representative.
Follow the prompts which are shown below.
U.S. Keyboard:
Answer Y (U.S. keyboard is the default)
Step 1 screen is displayed
Creating a QNX Hard Disk Partition.
Value point machine:
Answer N (No is the default)
Verify hard disk type (IDE or SCSI)
1a Verify drive size (Accept defaults)
The installation program will then run either "fsys.ide" or
"fsys.scsi" device driver.
1b Query free
1c Query QNX
1d Fdisk
The fdisk hard drive partition table screen is then displayed.
If no changes are needed to the partition table press Q to quit,
otherwise, refer to the QNX documentation for a full descrip-
tion of the Fdisk Utility.
Initializing the QNX file structure
STEP 2
2a mount -p /dev/hd0
Warning QNX partition found (if reinstalling QNX only)
2b dinit -hq /dev/hd0t77
2c mount hd0t77 /hd
Which test do you want?
Answer V.
INSTALLING QNX FOR OIS12 (SOFTWARE RELEASE 5.1A or 5.2)
INSTALLING SOFTWARE
A - 13
Advertisement
Table of Contents
