Hisense DHGA80 User's Operation Manual page 49

Problem/error
Laundry not dried
or drying takes too
long
Drum lighting error
Errors indicated on the display unit may include the following:
Problem/error
E0
E1
E2
E3
Cause
• Filters are not clean.
• Dryer is placed in a closed
room; room that is too cold;
or room that is too small and
the air overheats as a result.
• Laundry was not sufficiently
wrung or spun.
• Amount of laundry dried in
the appliance is too large or
insufficient.
• Laundry (such as bedding)
gets tangled into large balls.
• There is no lighting when the
dryer door is opened.
Indication on the display unit
and description of error
Control unit failure
Temperature sensor failure
Communication error
Pump error
What to do?
• Clean the filters (see chapter
»CLEANING AND MAINTENANCE«).
• Make sure there is adequate supply of
fresh air to the dryer; for example, open
the door and/or window.
• Check if the temperature in the room
where the dryer is installed is too high
or too low.
• If the laundry is still wet after the drying
cycle, repeat the drying and select an
appropriate drying programme (after
cleaning the filters).
• Use a suitable programme or extra
functions.
• Close the buttons or zippers on the
laundry before drying. Select a suitable
programme (e.g. the program Large
Items).
• After the drying process, loosen the
laundry and select an additional drying
programme (e.g. Time Dry (Timed
drying program).
• Disconnect the dryer from the power
mains and call an authorized service
unit.
What to do?
Call service centre.
Call service centre.
Call service centre.
Call service centre.
49