Table of Contents
Advertisement
Important Notes Prior To Installation
1. All PCS PulseWorx™ Wall Switch Dimmers require a neutral (white) connection wire.
About Your WS1E Wall Switch Dimmer
The WS1E Wall Switch Dimmer (Figure 1) is a high quality light-switch/ dimmer that not only allows for
local rocker switch control of electronic low voltage AC lighting ballasts or transformers but also
incorporates PCS's innovative UPB™ two-way powerline communication technology that gives it the
ability to be remotely controlled by other UPB™ compatible controllers. The WS1E is highly
configurable to allow for behaviors customized to each individual's desires. The WS1E is capable of
storing up to 16 preset light levels and fade rates to create powerful lighting scenes. The WS1E is also
capable of transmitting UPB™ messages (including a current light level report) when rocker switch
events occur. The WS1E is capable of being set to a non-dimming mode in order to control such loads
as fluorescent lights.
Multi-Colored
LED
Top Rocker
(On/Bright)
Bottom Rocker
(Off/Dim)
About Your RWS Remote Wall Switch
The RWS Remote Wall Switch (Figure 2) is a low cost (optional) companion device to the WS1E Wall
Switch Dimmer. The RWS has a Decora-style rocker switch that controls the WS1E in the same exact
way that its local rocker switch does.
Break-off Tabs
Black
White
Red
Yellow
Ground to Case
Figure 1: WS1E Wall Switch Dimmer
Page 2 of 11
19215 Parthenia St., Suite D
Northridge, CA 91324
pcssales@pcslighting.com
www.pcslighting.com
https://pcswebstore.com
Line
Neutral
Load
Control wire from RWS
(wire must be capped off
if not used)
P: 818. 701.9831
Advertisement
Table of Contents
