Pentair INTELLISYNC Installation Manual page 4

4
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
the user enough space to stand clear of the filter and pump during system start-up, shut
down or servicing of the system filter.
General Installation Information
1. This equipment is not provided with integral Ground Fault Circuit
Interruptor (GFCI) protection.
2. The electrical supply for this product must include a suitably rated
switch or circuit breaker to open all ungrounded supply conductors
to comply with in accordance with the current National Electrical
Code (NEC), NFPA 70 or the Canadian Electrical Code (CEC), CSA
C22.1. All applicable local installation codes and ordinances must
also be adhered to. The disconnecting means must be readily
accessible to the tub occupant but installed at least 10 ft. (3.05 m)
from the inside wall of the pool.
For information about the Virginia Graeme Baker Pool and Spa Safety Act,
contact the Consumer Product Safety Commission at (301) 504-7908 or
visit www.cpsc.gov.
NOTE: Always turn off all power to the pool pump before installing the
cover or working on any suction outlet.
RF Exposure Requirements: The antenna(s) used for this device must be
installed to provide a separation distance of at least 7.0 inches (20 cm)
from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
L' a ntenne (s) utilisé pour cet appareil doit être installé pour fournir une
distance de séparation d' a u moins (20 cm) à partir de toutes les personnes
et ne doit pas être co-localisés ou fonctionner en conjonction avec une
autre antenne ou un autre émetteur.
IntelliSync Control and Monitoring System Installation Guide
For Installation of Electrical Controls at Equipment Pad (ON/OFF
Switches, Timers and Automation Load Center)
Install all electrical controls at equipment pad, such as on/off
switches, timers, and control systems, etc. to allow the operation
(startup, shut-down, or servicing) of any pump or filter so the user
does not place any portion of his/her body over or near the pump
strainer lid, filter lid or valve closures. This installation should allow