Pentair INTELLISYNC Installation Manual page 3

IMPORTANT WARNING AND SAFETY INSTRUCTIONS
All applicable local installation codes and ordinances must also be adhered to. Improper installation
will create an electrical hazard which could result in death or serious injury to pool users, installers
or others due to electrical shock, and may also cause damage to property. Always disconnect the
power to the pool light at the circuit breaker before servicing the light. Failure to do so could result
in death or serious injury to serviceman, pool users or others due to electrical shock.
(6) Unconsciousness resulting in danger of drowning. The use of alcohol, drugs, or medication can
greatly increase the risk of fatal hyperthermia in hot tubs and spas.
The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia in
hot tubs and spas.
Do not use this product to control an automatic pool cover Swimmers may become entrapped
underneath the cover. For units intended for use in other than single-family dwellings, a clearly
labelled emergency switch shall be provided as part of the installation. The switch shall be
readily accessible to the occupants and shall be installed at least five (5) feet (1.52 m) away,
adjacent to, and within sight of, the unit.
Except for listed spa-side remote controls, install a minimum of five (5) feet (1.52 m) from the
inside wall of the pool and spa.
The electrical supply for this product must include a suitably rated switch or circuit breaker
to open all ungrounded supply conductors to comply with the current National Electrical Code
(NEC), NFPA 70 or the Canadian Electrical Code (CEC), CSA C22.1. All applicable local installation
codes and ordinances must also be adhered to.
Use only copper supply conductor' s rated for 60C/75C sized based on ampacity to support all
loads (refer to NEC tables).
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION!
Always disconnect power at the circuit breaker before servicing the
enclosure or equipment connected to the enclosure.
Improper installation can create an electrical shock hazard that can result
in death or serious injury.
Water temperature in excess of 100° F (37.7° C) may be hazardous to your
health. Prolonged immersion in hot water may induce hyperthermia.
Hyperthermia occurs when the internal temperature of the body reaches
a level several degrees above normal body temperature of 98.6° F (37° C).
Effects of hyperthermia include: (1) Unawareness of impending danger. (2)
Failure to perceive heat. (3) Failure to recognize the need to leave the spa.
(4) Physical inability to exit the spa. (5) Fetal damage in pregnant women.
IntelliSync Control and Monitoring System Installation Guide
3