Specifications; All Models - Tripp Lite SUPER 10+TEL Instructions Manual

Connect the coaxial cable from the antenna/CATV wall jack directly to the Super 10+TEL DBS
coaxial jack labelled "ANT/CATV IN". If you are also connecting a satellite dish, connect the
coaxial cable from the satellite dish to the Super 10+TEL DBS coaxial jack labelled "SAT IN".
If you are connecting a satellite receiver, connect two coaxial cables from the receiver to both of the
Super 10+TEL DBS coaxial jacks labelled "OUT", corresponding to the dish and wall jack inputs.
If you ARE NOT connecting a satellite dish (as illustrated below), connect a coaxial cable from the
device to be protected (VCR/TV) directly to the coaxial jack labelled "ANT/CATV OUT".
SUPER 10+TEL DBS TYPICAL CONNECTION DIAGRAM
(protecting satellite receiver, TV, VCR and stereo)
SAT ANT/CATV
IN OUT IN OUT

SPECIFICATIONS

Surge Energy Absorption (joules):
Surge Current (NM/CM):
Telephone Line Protection*:
Coaxial Protection**:
* 2 female "RJ" jacks; 260V peak +/- 10% (clamping voltage);<1 picosecond (response time); 6Kv, 10 microseconds (peak transient
input voltage); 2 pair (wires 2, 3, 4, 5) protected
** 4 female "F" coaxial connectors; 24,000 amps (peak pulse power dissipation); 240 joules energy absorption; Less than .5 dB
insertion loss

ALL MODELS

Let-Through Voltage:
UL 1449 (1998 rev.):
Response Time (Normal Mode):
Protection Modes:
EMI/RFI Line Noise Filtering:
AC Outlets:
AC Line Cord:
Dimensions (HxWxD, in.):
Agency Approvals:
Super 10+TEL Super 10+TEL Deluxe
2300
42.5/54.5 ka
two line
-
<35 volts
330 volts
Instantaneous (0 ns),
except Super 10+TEL DBS: <1 ns.
Line to Neutral, Line to Ground, and Neutral to Ground
>80 dB @ 1 MHz
10 NEMA 5-15R
10 ft., 14 gauge, 3 conductor grounded
2 x 3½ x 10¾
UL 1449 TVSS, UL 1363, UL 479A, UL 1283, cUL
Super 10+TEL DBS
2800
49/54.5 ka 42.5/54.5 ka
two line
- two signal lines
3
2100
one line
Canadian National
Standards
Certified by UL