Table of Contents
Advertisement
* * * * * TST? (Test Query)
This command requests the results of the self-diagnostic
stored in the buffer.
The responses for each self-diagnostics are as follows.
1: Initial Self-Diagnostics
2: VSW-45 board sense
3: SEC-39 board sense
4: Flash memory
* * * * * FLAGS? (Flag Query)
This command requests the flag information.
The following five flags are defined.
Power cycled on: Returns "yes" only one time when
power is turned on.
EDH now:
Returns "no" at all times.
EDH in past:
Returns "no" at all times.
EDA now:
Returns "no" at all times.
EDA in past:
Returns "no" at all times.
* * * * * STATUS? (Status Query)
This command requests the current operation status.
There are two varieties of statuses, one is "TRANSITION"
(during transition) and the other is "IDLE" (not during
transition).
* * * * * CMDERR? (Command Error Query)
When an error detected by the error check for received
command, the content stored in the buffer. This command
requests the contents of the command error buffer.
DEP-100
No error
Error occurred
Exist
No board
Exist
No board
No error
Check sum error
* * * * * MSG? ###### (Message Register Query)
This command requests the error/warning status that occur
in the DEP-100.
And if detailed operation status exists, it can be requested.
"######" is a register number, and it is defined as follows.
Register No.
Description
+5 V Fuse error
9
_5 V Fuse error
39
65
FAN stop
108
RAM error
124
Flash memory error
201
VSW-45 board sense error (No board)
202
SEC-39 board sense error (No board)
HELP: TST? (Help: Test Menu Query)
This command requests the self-diagnostics menu.
The DEP-100 supports the following self-diagnostics
menu.
Test No.
Description
1
Initial Self-Diagnostics
2
VSW-45 board sense
3
SEC-39 board sense
4
Flash memory
DEVID; device-id (Device ID Set)
This command is used to set the device-id.
This setting data will be reflected in "Device ID" of
response to "*IDN?" command.
When the setting is complete, the DEP-100 returns
"*ATN: OPC;".
LDSW TYPE; module (Load Software)
This command is used to download the software module.
The software module which downloaded is stored in flash
memory. (The DEP-100 operates with this software
module from next boot-up.)
When downloading is complete, the DEP-100 returns
"*ATN: OPC;".
2-4. ISR
2-5 (E)
Advertisement
Table of Contents
