U.S.SAWS ACH GB Series Operating Manual page 6

Symbols & Labels
THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS
MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR
WARNING
CAUTION
IMPORTANT
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE TOOL.
Guide Bar and Diamond Chain Installation
Read the operator's manual carefully and understand the
STEP 1
contents before you use this equipment.
Loosen side cover nut an remove side
cover.
STEP 2
Always wear a protective helmet
Place bar onto saw chassis and ensure the
bar sits over bar spacers on stud bolts.
Always wear breathing protection
Always wear hearing protection
Always wear protective glasses or full face protection
STEP 3
Mount the diamond chain on the guide bar
starting at the drive sprocket and continue
Always use ground fault protection
over the guide bar nose.
STEP 4
Install the side cover and ensure chain
adjustment pin engages hole in bar. Do
not fully tighten side cover until after chain
is properly tensioned.
SET-UP
UNSAFE PRACTICES.
A potentially hazardous situation exists which, if not avoided, could
A potentially hazardous situation exists which, if not
result in death or serious injury.
avoided, could result in death or serious injury.
A potentially hazardous situation exists which, if not
A potentially hazardous situation exists which, if not avoided, may
avoided, may result in minor or moderate injury or
result in minor or moderate injury or property damage.
property damage.
A potentially hazardous situation exists which, if not avoided, may
A potentially hazardous situation exists which, if not
result in product or property damage.
avoided, may result in product or property damage.
Air Powered Chain Saw
STEP 5
Make sure all the drive links are inside
the guide bar groove then lift the bar nose
and tension the chain by turning the screw
clockwise.
SYMBOLS & LABELS
TITLE
THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND T
ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HA
STEP 6
Before cutting, check for proper tension by
WARNING
pulling the chain around the bar by hand. If
you cannot easily pull by hand, the chain is
too tight and needs to be loosened slightly.
CAUTION
Be aware that the guide bar rails may
develop sharp edges over time so always
pull the diamond chain by the diamond
IMPORTANT
segments.
A potentially hazardous situation
could result in death or serious i
A potentially hazardous situation
may result in minor or moderate
A potential situation exists whic
6
product or property damage.
633GC