U.S.SAWS ACH GB Series Operating Manual page 5

THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS
MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR
WARNING
CAUTION
• Always turn the compressor source OFF, and ensure air lines are decompressed
and disconnect the chain saw from the air hose (even when the compressor is
OFF when performing maintenance on the saw including chain tensioning.
IMPORTANT
• Never use equipment that is not functioning properly. Have the saw repaired by a
qualified service personnel.
• Diamond chains require a minimum water pressure of 20 PSI. Insufficient
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE TOOL.
water supply may result in excessive wear to the chain which can lead to loss of
strength and chain breakage.
• Never start a diamond chain saw unless the bar, chain, and side cover are
properly installed.
General Safety Precautions
• Always wear protective clothing, including hard hat, eye protection, hearing
protection, and gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on the saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts, etc.)
and no unnecessary people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing
exhaust gases is dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.
Symbols & Labels
SAFETY
This symbol applies to all information listed on this page
UNSAFE PRACTICES.
A potentially hazardous situation exists which, if not
avoided, could result in death or serious injury.
A potentially hazardous situation exists which, if not
avoided, may result in minor or moderate injury or
property damage.
A potentially hazardous situation exists which, if not
avoided, may result in product or property damage.
Read the operator's manual carefully and understand the
contents before you use this equipment.
Always wear a protective helmet
Always wear breathing protection
Always wear hearing protection
Always wear protective glasses or full face protection
Always use ground fault protection
Air Powered Chain Saw
5