Related Manuals for American Standard TONIC 3/6 Lpf
Summary of Contents for American Standard TONIC 3/6 Lpf
- Page 2 Bring the toilet as the mark defined, and then mark the holes' position at the back of the toilet (as the figures shown in the pictures below) Use the 10mm. drillbit for bore the holse through the floor. Cutting of the waste connector as the figures shown in the pictures below. (In case lenght of trap way is 305 mm.) (In case lenght of trap way is not 305 mm.)
- Page 3 Connect the waste connector into the toilet The picture shows the completely connector into toilet. Installing the toilet with the floor Fixing the toilet with the floor By using the screw with the floor fixing set (supplied) Lift the toilet assembly and install After the installation with above by assemblings the outlet edge of instruction, check the levelness...
- Page 4 Install The Toilet Seat (See the manual for installing Seat&Cover) Install the toilet seat and apply silicone sealant around the bowl.