Specifications - Tripp Lite SmartPro SMART1500RM2U Specification Sheet

SNMPWEBCARD), or the monitoring of any number of additional UPS systems over IP with included PowerAlert monitoring software.
Communications ports support messaging of UPS and line power status, including on battery, low-battery, power restored, AC line voltage,
DC battery voltage and remaining battery capacity
Supports timed inverter shutoff after unattended shutdown, activate self-test and UPS output power control for a delayed or immediate
reboot of connected devices
Supports Tripp Lite's WatchDog software application to restore unresponsive programs by systematically restarting applications, operating
systems and ultimately rebooting completely locked computers by momentarily switching UPS power off and back on again (requires
optional WATCHDOGSW)
Built-in accessory slot supports SNMP with optional SNMPWEBCARD adapter
Emergency Power Off (EPO) interface with cable
Multi-function audible alarms and set of 5 front panel LEDs
Network-grade AC surge suppression
Attractive all-black color scheme
UPS battery set ships fully assembled and ready for installation, no time consuming connection of internal batteries by user is necessary

Specifications

OUTPUT
Output Volt Amp Capacity
(VA)
Output kVA capacity (kVA)
Output Watt Capacity
(watts)
Output kW capacity
Output power factor
Nominal Output Voltage(s)
Supported
Frequency compatibility
Output voltage regulation
(line mode)
Output voltage regulation
(Battery mode)
Built-in UPS output
receptacles
Built-in controllable
switched load banks
Output AC waveform (AC
mode)
Output AC waveform
(battery mode)
INPUT
Rated input current (at
maximum load)
Nominal Input Voltage(s)
Supported
UPS input connection type
Input circuit breaker
UPS Input cord length (ft.)
1500
1.5
1000
1
0.7
120V
60 Hz
-21%, +8%
+/- 5%
8 5-15R outlet(s)
Two switchable two-outlet 5-15R load banks
Sine wave
Pure Sine wave
10.4A
120V AC
5-15P
15A
10