Using Your Wine Cellar - Inalto IWCD46.1 User Manual

Using your Wine Cellar

Before use
Final checks before operating the appliance
1. Make sure there is sufficient space for air circulation around the appliance .(Please see page 13 of Instruction
Manual titled 'Installation requirements' for this information).
2. The feet have been adjusted for perfect leveling.
3. Clean the compartment per recommendation in section "Care and Maintenance".
4. Plug in the appliance and it will start operation to the default temperature setting.
5. The LED display may not show the selected temperature whilst the appliance first gets to the correct temperature.
This is normal, and the display will be corrected automatically once the appliance has run for a few hours.
6. If the appliance is switched off, you should allow five minutes before switching it on again to prevent the risk of
unnecessary damage to the compressor.
Please note :
The appliance will work continuously until it gets to correct temperature. Continuous noise from the compressor and
refrigeration system is normal, this is not a defect.
Arranging wine in your wine cooler.
Before putting the wine into the wine cooler, please ensure the shelves are correctly in place.
Adjust the temperature of the wine cooler.
Allow several hours to let bottles reach the desired temperature.
Fill the wine cooler with your choice of wine bottle. Lay the wine bottles in a horizontal position and ensure they sit on
the shelf securely (see diagram).
Please be aware that this wine cooler is designed to fit 0.75 litre Bordeaux style wine bottles (see bottle dimension).
Using different size bottles in the wine cooler may prevent the door from closing, and limit the space between shelves
and between bottles. When using a different size wine bottle we recommend to take out a shelf or rearrange the bottles
to suit the wine bottle size.
Do not exceed the capacity that the appliance is able to handle. Follow below bottle loading diagram.
shelf 1
shelf 2
shelf 3
shelf 4
shelf 5
bottom
Shelf 1-5 : Loading diagram for 8 bottles on each shelf , max loading 8 bottles only.
Bottom : 6 bottles place at bottom directly, no shelf, max loading 6 bottles only.
Caution:
Condensation may be found on the glass door during summer time or humid temperatures. This is normal. Wipe it with
a damp cloth.
Remove the shelves
To remove a shelf from the wine cooler, first remove all bottles from the shelf, then pull out the shelf until it stops. Lift up the
inner end of the shelf up, then the whole shelf can be pulled out from the cooler.
8
USER MANUAL
Diagram for shelf 1-5 loading
10
Diagram for bottom loading
PAGE 8