Polygroup SCP112781A Assembly Instructions

TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
-Set up and light up your tree in less than 10 minutes! Carefully follow the instructions below on how to
quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface. (See Fig. A)
Fig. A - Tree Stand Assembly
Fig. B - Tree and Light Assembly
Section 3
3. Each tree section is numbered with a tag. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top. Start with the bottom section and remove protective
cap before inserting into the assembled stand. Make sure the pole is firmly inserted and secured into
the stand.
5. Please remove protective cap from middle section(s) and continue inserting into the bottom section
until the tree top is inserted.
6. Allow branches to fall into place or gently pull up and out. When adjusting branches, be sure that all
wires are free of branch hinges.
7. (For pre-lit trees only) Connect the plug(s) securely and insert the green label extension cord plug into
the wall outlet (see Fig. B ) and Your entire tree should now be lit. If some bulbs do not light or flicker,
search for any loose plugs and/or broken, loose or missing bulbs. Replace bulbs promptly in order to
maintain the performance and life expectancy of your pre-lit tree.
8. Begin to shape the branches and tips working from the bottom to the top. Start with tips farthest from
the pole and fan out one to the right, one to the left and one at the center of the main stem. (See Fig. C)
Fig. C
Top view
9. After shaping the entire tree following the previous step, slightly upsweep all branch tips for a uniform
look. Shift branches to fill any gaps. Your Christmas tree is now complete and ready to be decorated.
MODEL #: SCP112781A
cETL: 75G0M0600S
Polytree®!
Section 1
100S
100S
100S
Section 2
50S
50S
100S
100S
Side view
This tree assmebles with Quick Set®
Unfold the legs and lay the
stand in a flat area. Then slide
the locking disc downward and
snap into place.
*Electrical Rating For The Tree
(For Indoor Use Only)
2.04A 120V 60Hz
Do Not Tamper
Internal Parts
Remove the
protective cap
Do Not Tamper
Internal Parts
Remove the
protective cap
Insert
Green Label
Plug Into Wall
Outlet