Advertisement
Before using your new Speaker System please review the
following Instructions, for safety and investment.
INSTRUCTIONS
Before connecting the speaker, make sure the system is OFF and the controls on the
minimum level. On the contrary the system could damage.
1. Plug the power cable to the AC outlet and to the system and the speaker
2. Plug the microphone in the "MIC" input
3. Connect (CD, DECK, MP3, DVD, etc) on "LINE IN" input
4. Turn ON the system. A green LED will light up to indicate the speaker is ON
5. Set the volume on low level on the MIC and the LINE IN input
6. Increase the master volume (placed on the right side of the LINE OUT *connector)
7. Set TREBLE and BASS controls to equalize the sound
8. A red LED will light up when the system detects overload power.
You have to decrease the volume.
CAUTIONS
Do not place the microphone against the speaker, it can cause feedback echo and it
will damage the system
EXTRA FUNCTIONS
6.3 And XLR connectors marker as LINE OUT can handle an ampli er or even
another powered speaker cabinet. On the bottom of the speaker there is a hole to
place a stand.
Electrical Safety
All products are tted with a detachable power cord (supplied) which connects to
the AC mains and the back panel of the loudspeaker. The power cord has an IEC
female connector on one end and male mains connectors on the other end. This
cord is supplied specially to accommodate the di erent worldwide safety and
electrical code requirements. The power cord supplied with your product has a
3-pin type plug. Do not cut o or damage the grounding plug. Like any electrical
appliance, your EON powered speakers should not be used in water or when wet.
Product design and speci cations are subject to change without previous notice.
2
www.PyleUSA.com
Advertisement
