Advertisement
Thanks for using Natural Gate and we hope it gives you a link to the world we naturally fit into!
Specifications
●
HIT trigger threshold: +0.25 V
●
Envelope output amplitude: +10 Vpp, unipolar (0 to +10 V)
●
All IO DC-coupled
Input Impedance: 25 kΩ to 50 kΩ
●
Headroom (max passable signal before clipping): >= +/-11.9 V for +/-12.0 V power, 50 kΩ load
●
Protection (IO)
●
●
All IO will handle shorts to any voltage from +12.0 V to -12.0 V *
●
All outputs current limited to 35 mA
Protection (Power)
●
Active high-speed reverse voltage
●
Overcurrent (fused)
●
●
Power Requirements: +/-12 V (+/-5%) @ 80 mA (average)
●
Size: 12HP W x 128.5 mm H x 25 mm D**, 38mm D***
●
W, width is nominal HP. Actual width is 12HP = 5.08 * 12 = 60.96 mm minus standard
fitment tolerances.
**D, depth measured from back of front panel to back or rear panel)
●
●
***D, depth measured from back of front panel to back with minimum power cable
bend radius clearance
* Shorting any output is not recommended, of course, and should be avoided. We test for duration of
at least 5min for each test scenario. That being said, it is impossible to test our instruments with
every other Eurorack module and power/distribution scheme. Therefore we cannot guarantee full
assurance in regards to IO safety and damage. See our Warranty section for responsibilities. Patch
carefully!
Tested PSUs (this does not guarantee compatibility and makes no statement on noise, reliability, or
safety - see W arranty section below): Doepfer PSU2, Bel Power 150W linear, Intellijel TPS80W MAX,
Intellijel TPS30W MINI, Tiptop Audio Studio Bus, Tiptop Audio uZeus, and several others.
Any specifications are subject to change without notice.
Advertisement
