Maintenance; Transporting And Storing Outboard Motor; Storing Outboard Motor - Yamaha F30 Owner's Manual

EMU43253
Transporting and storing
outboard motor
EWM02621
WARNING
USE CARE when transporting fuel tank,

whether in a boat or car.
DO NOT fill fuel container to maximum

capacity. Gasoline will expand consid-
erably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. When

transporting and storing the outboard
motor, disconnect the fuel line from the
outboard motor to prevent fuel from
leaking.
Never get under the outboard motor

while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
Do not use the tilt support lever or knob

when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional sup-
port device to secure it in the tilt
position.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
Disconnect the fuel hose from the fuel joint

on the outboard motor.
Tighten the fuel tank cap and its air vent

screw.
Store the fuel tank in a well-ventilated

place.
Store the fuel tank in a place that is stable

and not exposed to shocks.
When the outboard motor is tilted for a pro-
longed time for mooring or trailering the boat,
make sure to follow the procedure listed be-
low.
Disconnect the fuel hose from the fuel joint

on the outboard motor.
Tighten the fuel tank cap and its air vent

screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the
tilt position using a motor support device
such as a transom saver bar. Consult your
Yamaha dealer for further details.
EMU28282

Storing outboard motor

When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
It is advisable to have your outboard motor
serviced by an authorized Yamaha dealer
prior to storage. However, you, the owner,
with a minimum of tools, can perform the fol-
lowing procedures.
ECM01081
NOTICE
To prevent problems which can be

caused by oil entering the cylinder from
the sump, keep the outboard motor in

Maintenance

ZMU03659
75