Subscribe to Our Youtube Channel
Related Manuals for Gbord EN-103
Summary of Contents for Gbord EN-103
- Page 1 EN-103 PCIe 10G 5-Speed Multi-Gigabit Network Card User’s Manual Ed – 21 June 2019...
- Page 2 This equipment has been tested and found to comply information and technical support. with the limits for a Class A digital device, pursuant to http://www.gbord.com/ Part 15 of the FCC Rules. These limits are designed to Copyright and Trademarks provide...
-
Page 3: Table Of Contents
Table of Contents Chapter 1: Introduction ......................... 4 1.1 Module Physical Features ......................4 1.2 System Requirements ........................5 1.3 Package contents ........................5 Chapter 2: Installation ........................... 6 2.1 Hardware Layout .......................... 6 2.2 Hardware Installation ........................6 2.3 Driver Installation ........................7... -
Page 4: Chapter 1: Introduction
Chapter 1: Introduction This card is a Multi-Gigabit network adapter that’s runs on a high speed PCIe x4 host bus interface. This card hosts the Tehuti’s new 3rd generation TN4010 controller and optimized 10 Gigabit Ethernet MAC designed for low-power, low-cost, single-port connectivity required by Application Servers and Workstations. The TN4010 MAC is paired with Marvell®... -
Page 5: System Requirements
1.2 System Requirements Hardware The following system specs are recommended minimum PCIe slot: Available 4-Lanes PCI-Express slot gen 2.0 or later Processor: Quad Core 3.0GHz or higher RAM: 4GB memory or higher Software Operating systems supported are (both 32 and 64 bits) Windows 7 Windows 8.1 ... -
Page 6: Chapter 2: Installation
Chapter 2: Installation 2.1 Hardware Layout Link/Activity Indicator: When the LED is off, there is no link between the PCIe 10G When the LED is on, a link is established, but there is no traffic on the network III. When the LED is flashing, there is traffic on the network to which the 5-Speed Multi-Gigabit Network Card is connected Link Speed Indicator: When the LED is lit orange, a 10GBase-T link is established... -
Page 7: Driver Installation
2.3 Driver Installation The following section shows you how to install 5-Speed Multi-Gigabit Network Card driver on different operating systems. Installation for Windows Insert the provided CD into your disk drive. The CD-ROM will start automatically. The following screen will show up and please click “Install Driver”. - Page 8 Please click “PCIe 10G” to start the installation. Follow the instructions on screen to install the driver. Installation for Linux 1. Insert the provided CD into your CD-ROM drive. 2. Extract the compressed driver source file to a certain directory by the following command: (Please copy the driver file“tn40xx-x.x.x.x.tgz”...
- Page 9 Verify for Windows Click on the “Device Manager” tab in the Windows Control Panel. Start > Control Panel > Device Manager Entry “Network adapters” item, and you can read “Tehuti Networks 10GbE Adapter” in the Device Manager. Verify for Linux 1.
Need help?
Do you have a question about the EN-103 and is the answer not in the manual?
Questions and answers