Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beurer LR 200
Summary of Contents for Beurer LR 200
- Page 1 LR 200 EN Air purifier Instructions for use...
- Page 2 Humans spend a large proportion of their time indoors. The air indoors is often polluted with dust particles, pollen, animal hair, odours, harmful gases as well as various bacteria and viruses. The LR 200 air cleaner cleans the ambient air using a three-layered filter system and an additional integrated ioniser.
-
Page 3: Table Of Contents
Principle of air cleaning 1. The air cleaner’s fan sucks in the contaminated air. 2. The pre-filter filters out larger particles such as dust, dirt and hairs. 3. Next, the activated carbon filter filters formaldehyde, benzene and other poisonous gases and unpleasant odours out of the ambient air. -
Page 4: Warnings And Safety Notes
Disposal in accordance with the Waste Elec- Read the instructions trical and Electronic Equipment EC Directive – WEEE The device has double protective insulation and „Geprüfte Sicherheit“ safety mark therefore complies with protection class 2. 3. Warnings and safety notes Read the notes carefully! Non-observance of the following information may result in personal injury or material damage. -
Page 5: Intended Use
Handling IMPORTANT The device must be switched off and disconnected from the mains after every use and before cleaning. • Do not place any objects in device openings or in rotating parts. Ensure that the moving parts can move freely at all times. •... -
Page 6: Initial Use
Display and buttons ON/OFF FILTER RESET ION SLEEP 2H 4H 8H 1 ON/OFF button 3 Ioniser/Sleep mode Switches the device on/off Switching the ioniser or night mode on/off.. If the light below “Filter reset” is flashing, change the filter. After changing the filter, hold down the on/off button to reset the filter change display. -
Page 7: Usage
7. Usage 7.1 Switching on the air cleaner 1. Always follow the instructions in chapter “5. Initial use”. 2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard. 3. Press the ON/OFF button ( ) to switch on the air cleaner. -
Page 8: Filter Change
7.5 Filter change The three-layered filter should be replaced with a new one after 4320 operating hours. After 4320 operating hours, the red „Filter reset“ LED flashes above the on/off button. To change the filter, proceed as follows: 1. Press the ON/OFF button to switch off the air 2. -
Page 9: Cleaning And Maintenance
If you wish to change the combi filter at specific personal intervals (e.g. every six months), there is a sticker on the upper edge of the combi filter on which you can enter, for example, the date it was inser- ted or changed. -
Page 10: What If There Are Problems
EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact the local authorities responsible for waste disposal. 12. Technical specifications Model LR 200 Mains voltage See type plate on the device Output... -
Page 11: Warranty / Service
During the warranty period, should this product prove to be incomplete or defective in functionality in accor- dance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of charge, in accordance with these warranty conditions. - Page 12 BEURER GmbH • Söflinger Str. 218 • 89077 Ulm (Germany) www.beurer.com • www.beurer-healthguide.com...
Need help?
Do you have a question about the LR 200 and is the answer not in the manual?
Questions and answers