Specifications: Used voltage:AC110V-240V,50/60Hz Light source:350W Color temperature revise:6700K Linear dimming:mechanical linear dimming0~100 Fixed color:13color + white light(half color effect is available) Fixed gobo :13fixed gobo + white light Prism:8prims,48prism,double prism superposition,bilateral rotation Color chips:1colorful chip pulverization:one independent frost effect,facula soft and natural Electrical motor:three-phase machine,silence and high speed main board Channel control:16/20channel Size:32*22*58...
Page 3
Menu construction Interface---Manual operation ---Setting ----running mode ----DMX address ----channel mode ----X inversion ----Y inversion ----XY interchange ---- XY encoder ----DMX signal ----power on light ----color ring linear variation ----reset default setting system --software version --restoration adjust --sensor monitor --system error --permission setting --DMX monitor...
Page 4
Manual control This interface is use to control the light , in the same time enter the mainframe condition(do not accept DMX signal,send the DMX signal from trunk to the slave machine) 。 Manual menu set the standard 16 channel mode or 20 channel mode according to the setup menu,corresponding dispaly 16 channel and 20 channel。...
Page 5
Option Illustrate Operation mode Slave condition: receive DMX signal from controller or main engine Self Main engine condition : self working and send DMX working1 signal to slave engine Self working2 random Voice control DMX address 1~512 press“confirm”key to enter redact condition。press “confirm ”key to enter redact status 。...
Page 6
close Backlight keep lighting Open and light close Restoration after power on , bulb not working ( use bulb menu or controller to light the bulb) open Bulb light after on power , and wait for the bulb successful light then restoration Color ring linear open Color ring linear variation...
Page 7
DMX monitor RT monitor the signal of controller False information Illustration Fail reset Driver board no reply。 The telecommunication line that connect electric motor,gorge dispaly and gorge line broken,or the driver board broken。 error Pan rest failure Pan optoelectronic or Pan electric motor broken Tilt rest failure Tilt optoelectronic or Tilt electric motor broken Pan Hall error"...
Page 8
dimming dimming Gobo dish Gobo dish Prism 1 Prism 1 Prism rotation 1 Prism rotation 1 Prism 2 Prism 2 Prism rotation2 Prism rotation2 Zoom Zoom X fine dimming X fine dimming Y fine dimming Y fine dimming frost/colorful lens frost/colorful lens reset reset...
Page 9
EFFECT Remarks FAST ROTATION(forward) …… …… SLOW ROTATION(forward) SLOW ROTATION(forward) …… …… FAST ROTATION(reverse) order to facilitate CTB 8000 + WHITE memory, the color value CTB 8000 is always a multiple of 5. CTO 190 + CTB 8000 CTO 190 CTO 260 + CTO 190 CTO 260 Linear change:...
Page 10
units of color. GREEN AQUAMARINE + GREEN “Linear” AQUAMARINE “Nonlinear” selections of ORANGE the patches can be made AQUAMARINE through the setup menu. ORANGE RED + ORANGE WHITE + RED WHITE STOP/STOBE - channel 2 EFFECT Remark 252-255 OPEN Controlled dimming channel...
RANGE LAMP CONTROL- channel 16 EFFECT Remark 101-255 LAMP ON Lamp switch passing through the unused range and 10-100 LAMP OFF staying 5 seconds. UNUSED RANGE TIMING CHANNELS Timing Channel Channel function Remark Pan-Tilt time Pan-Tilt-(Pan fine-Tilt SLOW SPEED fine) ……...