Table of Contents
Advertisement
Receiving Instructions
Every unit is thoroughly tested and inspected prior to shipment. However, it is possible
that the unit may incur damage during transit. If you see damage when unloading, make a
note of it on the SHIPPER RECEIVER.
Remove all packing & strapping material, inspect for damage. IF DAMGE IS EVIDENT, FILE A CLAIM
WITH THE CARRIERIMMEDIATELY! Also, check fork size, type of power unit, etc., to see that the unit
is correct for the intended application.
Warnings & Safety Instructions
Insure that all employees understand and follow the following instructions
•
Read and understand the owner's manual before using or servicing the drum jack.
•
Do not use the drum lifter if any damage or unusual noise is observed.
•
Improper use of this drum lifter could result in injury and damage to load or equipment.
•
Always watch the drum lifter and any load on it carefully when it is being used or moved.
•
Do not overload this drum jack. Check capacity plate for loading weight and lifting height. Do
not handle unstable loads.
•
Operate truck only from designated operating load position.
•
Make sure that the drum has been exactly clamped when to lift.
•
Avoid sudden stops or quick turns to prevent accidental tipping of the load.
•
Park drum lifter on level surfaces and not in the way of other products
•
When parked, lower the carriage completely and make sure handle is in vertical position.
•
Travel slowly and with caution on slopes, always travel with load end down grades.
•
Do not perform any modifications to the drum lifter without manufacturer's approval. Failure to
receive authorization for changes to the equipment could void the warranty.
•
Do not use brake fluid or jack oil in the hydraulic system. If oil is needed, use an anti-wear
hydraulic oil with a viscosity grade of 150 SUS at 100°F, (ISO 32 @ 40°C), or a non-synthetic
transmission fluid.
•
Use only replacement parts either supplied or approved by the manufacturer.
Advertisement
Table of Contents
