Page 1
OPERATION & SERVICE MANUAL PORTABLE DRUM JACK (DRUM-55-S) ESTIL ANUFACTURING 2999 N , P.O. B 507, A , IN 46703 ORTH AYNE TREET NGOLA : (260) 665-7586 - (800) 348-0868 ELEPHONE : (260) 665-1339 URL: WWW.VESTILMFG.COM EMAIL: SALES@VESTIL.COM...
Page 2
DRUM-55-S PORTABLE DRUM JACK Introduction Read and follow the instructions contained in this operating manual. Only trained, well-informed personnel, who have been instructed in accordance with this operation manual, may use or work on the drum jack. This unit has a unique grapple to hold 55-gallon drums securely into the steel saddle prior to lifting it vertically.
Specification SPECIFICATION Model Number DRUM-55-S 1,000 lbs. Capacity Drum Lift Height from 3” Ground 29” x 42 ½ ” x 47 3/8” Overall Size (W x D x H) 29” Turning Radius Φ8” x 2” Steering Wheel Φ3” x 1 ½”...
Page 4
Receiving Instructions Every unit is thoroughly tested and inspected prior to shipment. However, it is possible that the unit may incur damage during transit. If you see damage when unloading, make a note of it on the SHIPPER RECEIVER. Remove all packing & strapping material, inspect for damage. IF DAMGE IS EVIDENT, FILE A CLAIM WITH THE CARRIERIMMEDIATELY! Also, check fork size, type of power unit, etc., to see that the unit is correct for the intended application.
OPERATION 1. Before lifting the load, follow these stages: a. Maneuver the unit to 55-gallon drum, secure drum in the steel (saddle) carriage of drum jack. b. Pump the handle, saddle clamp will grapple 55-gallon drum securely in the carriage (6-7 pumps). c.
Page 6
ADJUSTING RELEASE LEVER On the handle of this drum jack, you can find control lever (part # 1) which can be adjusted in three positions Raise – lever down (as shown in the photo) Drive – Neutral position lever in the center (as shown in the photo) Lower –...
the forks don't lower. C - If the jack don't descend when control lever (part # 1) is in the LOWER position, turn the nut (part # 18) clockwise until raising the control lever (part # 1) lowers the forks. Then check the DRIVE position according to item A and B to be sure the nut (part # 18) is in the proper position.
(you) for warranty service. Who may request service? Only a warrantee may request service. You are a warrantee if you purchased the product from Vestil or from an authorized distributor AND Vestil has been fully paid.