SignitePro CA18000 Series Manual page 11

INSTALLATION
INSTALLING IGNITOR BATTERY
NOTE: Battery is included.
1. Unscrew ignitor cap and insert included battery negative (flat) side down (see Fig. 4).
2. Replace ignitor cap.
3. Be sure to observe proper polarity (+/-) when installing or replacing the battery.
Damage due to improper battery Installation may void the warranty on the product.
4. Install/replace the battery according to the type and quantity stated in table below.
5. Remove battery when depleted.
6. For long periods of non-operation, remove the battery from all components for safety.
WARNING:
Do not use rechargeable silver oxide cell batteries
DO NOT dispose of batteries in fire. Improper disposal may cause
batteries to leak or explode.
PREINSTALLED FAN (OPTIONAL)
WARNING: This appliance is equipped with a three-prong
grounding plug for your protection against shock hazards and
should be plugged directly into a properly grounded three-prong
receptacle.
NOTE: If any of the original wire as supplied with the appliance
must be replaced, it must be replaced with a wire of at least an
equal temperature rating.
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Fig 4: Installing Ignitor Battery
Component Type of Battery
Ignitor
Battery Qty.
AAA 1
11
Fig .5: Grounded Three-
Prong Receptacle