Operation - Tarmo TAR004 Instruction Manual

6. Lift and lower the lifting device to ensure that the implement or its driveline does not
contact the tractor or the implement body in any position.
7. Connect the hydraulic hoses to the tractor.
8. There is an adjustment device in the lifting hose that restricts the lifting speed. Adjust it
so that the implement raises slowly.

OPERATION

ATTENTION! Tractor PTO shield and all mower guards must be in place at all times during
operation!
Transporting
NOTE: Always disengage PTO before raising mower to transport position.
1. When raising the mower to transport position, be sure that driveline does not contact
tractor or mower. Adjust and set the tractor's 3-point hitch lift height so that the
driveline does not contact mower deck in the fully raised position.
2. Be sure to reduce tractor ground speed when turning, leaving enough clearance so that
the mower does not contact obstacles such as buildings, trees or fences.
3. Select a safe ground travel speed when transporting from one area to another. When
traveling on roadways, transport in such a way that faster moving vehicles may pass
safely.
4. When traveling over rough or hilly terrain, shift tractor to a lower gear.
CAUTION: When traveling on public roads, use lights and devices for adequate warning to
operators of other vehicles according to the applicable legislation.
Preparation of the area to be mowed
1. Clear area to be mowed of objects and debris that might be picked up and thrown by
the mower blades.
2. Grass is best cut when it is dry. Mowing wet grass can cause plugging resulting in
grass clumps behind the mower.
3. Grass should be mowed frequently as shorter clippings deteriorate faster.
4. If mowing extremely tall grass, it is best to raise cutting height and mow the area, then
lower cutting height and mow a second time at the desired height.
Preparation
Before beginning to mow, the following inspection should be performed:
1. Check oil level in gearbox and add oil if needed.
2. Check that all plugs in gearbox have been replaced and tightened properly.
3. Be sure all mower knives, bolts and nuts are tight.
4. Make sure that all guards and shields are in place and securely attached.
5. Grease driveline shaft and all other grease fittings.
6. Clear area to be mowed of rocks, branches and other foreign objects.
7. Lower mower to ground. Let the tractor idle. Engage PTO.
8. Operate with 540 rpm PTO tractor.
9. At first begin mowing at a slow forward speed and shift up until the desired speed is
achieved - maintaining 540 PTO rpm.
10. Mower knives will cut better at a faster blade speed than at reduced throttle.
11. After mowing the first 10-15 meters, stop and check to see that the mower is adjusted
properly.
12. Do not make sharp turns or attempt to back up while mower is on the ground.
21