Gemini GD20SS User Manual page 10

Operating introduction
2.4 Swing button: (controlling the swing confition)
• When the machine is working,pressing air-plate to make stepping motor
ON/OFF, the corresponding swing indicator lamp light/quenching.
Stepping motor turn down(anticlockwise) to make air- plate turn 45°, then
turn up(anti-clockwise) to make air-plate turn 45°, then turn down(clockwise)
to make air-plate 45°, circularly like this.
• If we pressing"Swing"button to let it stop after stepping motor is working,
then pressing"Swing"button again to make stepping motor turn up(anti-
clockwise) to let air-plate turning 95°, then turn down (clockwise) to let air
plate turning 45°, then turning up(anti-clockwise) 45°, circularly like this.
• When powering on, stepping motor open 95°anti-clockwise, then stop, if
we don't start swing function, the stepping motor will close 25°1 time,
then open 25°to stop in every 15 minutes, (and stepping motor's turning
speed is faster 2 times than original.
• When powering on,the stepping motor will open 95°(anti-clockwise), then
stop; if we start swing function and then close,stepping motor will close
25°clockwise 1 time and then open 25°anti-clockwise to stop in every
15 minutes, (stepping motor's turning speed is fater 2 times than original).
Remark:
① It is 15 minutes from starting to close swing,
② If we start swing within 15 minutes, it will cancel above function,
③ Once start swing function, the circular movement will be canceled automatically,
④ Once swing function is closed, it will swing up 25°, then swing down 25° to stop circularly
2.5 Timer button: Reserving timing time. (Setting timing powering on or off:
00H, 01H, 02H, 03H, 04H...11H, 12H, 00H circularly)
• Timing powering on automatically condition:
- Powering on,pressing timing button to set timing powering on 00H,
01H, 02H, 03H, 04H......11H, 12H, 00H, the digit tube is blinking to
indicate it is in the state of timing powering on setting, it will turn into
indicating time of timing powering on if don't set timing, and as times
goes by, it will indicate preset remaining time.
Remark:
① When preset timing time is 00H,timing indicator lamp is not lighted(it indicates no setting
timing function), if we set timing time is 01H, 02H, 03H, 04H......11H, 12H, timing indicator
lamp is lighting(it indicate having setting timing function);
② If we preset the timing powering on time when machine is under standby mode and preset
the timing powering off time when machine is working;
③ When timing powering on is arriving, stepping motor will turn up 95°(anti-clockwise),
then stop, and machine will memorise previous working mode;
④ In the standby mode, pressing timing button and ON/OFF will operate and the buzzer
will warn, there is no reaction when pressing other button
P10