Supplied Parts; Parts Description; Intended Use; Unpacking The Appliance - Proficook PC-AE 1069 Instruction Manual

Supplied parts

1 base device with motor 1 centrifuge sieve
1 transparent cover
1 tamper

Parts description

1 Tamper
2 Filler opening
3 Transparent cover
4 Centrifugal sieve
5 Centrifuge casing
6 Drive wheel
7 Safety bracket
8 Switch
9 Base device with motor
10 Pomace containerr

Intended use

This appliance is intended for juicing fruits and
vegetables.
Do not insert any hard foodstuffs such as nuts or
chocolate.
It is exclusively intended for this purpose and may
be only used appropriately.
It may only be used in the manner described in
these operating instructions.
You may not use the appliance for commercial
purposes.
Use for any other purpose is considered improper
and not for the intended purpose and can result in
damage to property and personal injury.
The manufacturer shall not be liable for damages
caused by not intended use.

Unpacking the appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling
materials, cable holders, and carton packag-
ing.
3. Check the scope of deliveries for complete-
ness.
42
1 centrifuge housing
1 pomace container
4. If the packaging content should be incomplete
or if damages should be noticeable, do not op-
erate the appliance. Return it to the distributor
immediately.

NOTE:
There may still be dust or production remains on
the device. We recommend that you clean the
device as described under "Cleaning".

Preparations

For assembly, also refer to the illustrations on
page 3.
1. Set the device so that the switch points to-
wards you.
2. Tilt the safety handle to the right.
3. Attach the pulp container on the left side. In
the next step it is secured by the collar of the
centrifuge casing.
4. Attach the centrifuge casing on top of the base
casing.
The juicer outlet must face to the right.
WARNING RISK OF CUTS! THE CEN-
TRIFUGAL SIEVE IS SHARP!
5. Place the centrifugal sieve on top of the drive
wheel. Press it down. It clicks in place on the
drive wheel.
6. Check the centrifugal sieve! Feel under the
sieve edge. It should not loosen under slight
tension.
7. Attach the transparent cover. It reaches all the
way over the pulp container.

NOTE:
YOUR APPLIANCE IS EQUIPPED WITH
A SAFETY SWITCH. IT PREVENTS AC-
CIDENTAL MOTOR START. CHECK THE
CORRECT ATTACHMENT OF ALL COMPO-
NENTS, CENTRIFUGAL SIEVE AND
TRANSPARENT COVER.
8. Lock the safety bracket over the transparent
cover.
9. Place the juice jug to the right of the appliance.
10. Ensure that the control knob is set to "0" posi-
tion.