Signal Input And Output - Sony MAV-2000 Installation Manual

8. After installing the rack into the unit, fix the rack angle
on the rack using the supplied ornament washers and
the screws.
c
Tighten the screws of the rack angle completely.
If the screws are not tightened, the unit may slip from the
rack and fall, causing injury.
RK5 x 14
Ornament washers
RK5 x 14
MAV-2000

1-6. Signal Input and Output

The input and output signals of each connector on the
connector panel are as follows:
ETHER : 10BASE-T (8-pin Modular jack)
8
<External view>
Pin No. Signal
1 TX +
2 TX _
3 RX +
_
4-5
RX _
6
7-8 _
REMOTE : RS-422A (D-sub 9-pin, Female)
5
9
<External View>
Pin No. Signal
1 GROUND
2 OPERATE
3 WARNING
4 ERROR
5 _
6 _
7 _
8 _
9 GROUND
1-5. Rack Mounting
1-6. Signal Input and Output
1
1
6
1-9 (E)