Powering On/Off - GoPro SMART REMOTE User Manual

Charging
1. Slide and hold the latch lever in the
direction of the arrow (A), and then
pull the key out of the remote (B).
B
A
2. Insert the charging cable into the
remote until it clicks into place.
Powering On + Off
POWERING ON
Press the Power/Mode button .
3. Connect the other end of the
cable to a computer or other
USB power source.
Note: Be sure that the computer is
connected to a power source. If the
remote status screen does not indicate
that the remote is charging, use a
different USB port.
POWERING OFF
Press and hold the Power/Mode
button for two seconds.
2 sec
Pairing the Remote and Your Gopro
You can pair Smart Remote with any wireless-enabled GoPro. The remote can
control up to 50 cameras* at a time from up to 600ft (180m) away in optimal
conditions. Your camera recognizes only one remote at a time.
* Dependent on camera model, terrain, obstructions, electromagnetic interference,
and environmental conditions.
PAIRING YOUR REMOTE WITH YOUR HERO8 BLACK OR HERO7 BLACK
1. Power off the remote.
2. On your camera, complete these steps:
a. From the main screen, swipe down.
b. Tap Preferences > Connections > Connect Device > Smart Remote.
The camera will automatically begin pairing.
c. Power on the remote. If the remote was never paired with a camera, it will
automatically begin pairing. Otherwise, press and hold the Settings/Tag
button for four seconds to begin pairing. Once the devices are paired,
a confirmation will appear on each screen.
For information about using Smart Remote with other GoPro cameras,
see gopro.com/smart-remote-setup.
CONNECTING YOUR REMOTE AFTER PAIRING
After you've paired your remote and camera, you can start connecting through
your camera's Connections menu.
1. Power on your remote and camera.
2. On your camera, follow these steps:
a. From the main screen, swipe down.
b. Tap Preferences > Connections > Wireless Connections to turn on
wireless. (On GoPro cameras older than HERO7 Black, tap Connections >
Wireless Connections.)
Heads Up: Your camera will connect to the remote that was connected to
most recently.