Prince Hanger PHUS-0062 Quick Start Manual

IMPORTANT- Read Before Assembly
Please follow these safety precautions in order to ensure proper installation
and to prevent any bodily injuries and structural failures.
Please note that this unit includes poles and rods that are made out of steel, which can
cause bodily injuries and/or damages to the oor if dropped or held in an improper
manner during assembly.
1. This unit is designed for use by keeping the poles
xed to the oor and the ceiling. Therefore, it is not
safe for children to climb or hang on the unit.
Children should be under adult supervision at all
times to prevent any injuries.
2. Overloading the unit might cause it to become
unstable and either tip or collapse, which may cause
serious bodily injury and/or damage to personal
possessions.
3. In order to prevent any accidental collapses due to improper care, install the unit,
so that it is slightly tilted towards the wall, not perpendicular to the oor.
4. We recommend that you frequently examine the unit for any loose bolts or wobbling.
5. The curtains should be hand washed. They are not machine-washable.
Please note
The unit may collapse if it is not securely xed to the oor or if it is installed to a weak
part of the ceiling.
Di erentiating Between the Poles
The upper poles are thinner than the lower poles.
(Make sure the upper poles attach to the ceiling mount and lower poles to the oor
mount during installation.)
Manual
Fastening
Device
Set Screw
Before tightening the set screw After tightening the set screw a couple of times
Before installing the pole, tighten the set screw to the manual
fastening device a couple of times. (Note: Installing the pole with
the set screw too tight can damage the pole.)
Push the upper pole to the ceiling to set it upright and fasten it
1 by tightening the set screw completely.
(If the screw bolt is not tightened carefully, it can damage the
screw and a ect its abilities to fasten the device.
Example
Ceiling
4 inch
Assemble the xtures
(shelf brackets, rod brackets, etc.)
at least 4 in. away from the ceiling mount for
rm support.
Before Disassembly
Upper Pole
Set Screw
Lower
Pole
Lowering the pole by loosening the set
screw without holding onto the pole
may be dangerous. Please hold the upper
pole with one hand and loosen the set
screw with the other when lowering the
pole.
COMPLETE PARTS LIST
Product Components
*Check your inventory before beginning installation.
Ceiling Mounts (2)
Upper & Lower Poles
Curtain Rod Brackets (2)
(2 Sets)
Curtain Rods (1)
Wedges (2)-1.1/1.26 in.
Tie Bolts (2)
Upper Pole
(1.1 in.)
Hanger Rods (2)
Rod Brackets (4)
Rubber Rings (4)
Manual Fastening Device
Set Screws (2)
Lower Pole
(1.26 in.)
Curtain (1)
Floor Mounts (2)
Safety Bolt
(Located behind the shelf bracket)
T
ighten gently by hand after installing the rods
(Left-1) (Right-1)
Free Gift
Hanger Retriever (1)
2