General Laser Tool Safety Warnings - Skil ME9821-00 Owner's Manual

GENERAL LASER TOOL SAFETY WARNINGS

READ ALL INSTRUCTIONS BEFORE USING
THIS TOOL!
WARNING
using this tool. Class II laser product.
Do not remove or deface any
product labels .
DANGER
The laser beam can cause flash
blindness.
Do not operate this tool around
children or allow children to operate
this tool.
Do not place the tool in a position that may cause anyone to stare
into the laser beam, whether intentionally or unintentionally.
Do not use on surfaces, such as sheet steel, that are shiny and/or
reflective. Shiny and/or reflective surfaces could cause the beam to
bounce back at the operator.
Always turn the laser tool off when not in use . Leaving the tool
ON increases the risk of someone inadvertently staring into the
laser beam.
Do not attempt to modify the performance of this laser device in any
way. This may result in a dangerous exposure to laser radiation.
Do not attempt to repair or disassemble the tool. If unqualified
persons attempt to repair this product, serious injury may occur. Any
repair required to this laser product should be performed only by
qualified service personnel.
Use of other accessories that have been designed for use with other
laser tools could result in serious injury.
LASER RADIATION . DO NOT STARE INTO
BEAM . Only turn on the laser beam when
Avoid direct
eye exposure .
AVOID EXPOSURE / ÉVITEZ L'EXPOSITION
LASER RADIATION IS EMITTED FROM THIS
APERTURE / CET OUTIL PRODUIT UN RAYONNEMENT LASER
CAUTION/ATTENTION
LASER RADIATION-DO NOT STARE INTO BEAM
RAYONNEMENT LASER – NE FIXEZ PAS DES YEUX LE RAYON
LASER
OUTPUT < 1mW/CLASS II LASER PRODUCT, 630-670nm, 3V
2×1.5 V AAA Battery, COMPLIES WITH 21 CFR PARTS 1040. 1 0 AND 1040. 1 1
SORTIE < 1 mW/PRODUIT LASER DE CLASSE II, 630-670nm, 3 V
2×1.5 V AAA Battery, CONFORME AUX NORMES 21CFR ARTICLES
1040.10 ET 1040.11
Model / Modèle: ME9821-00
MADE IN CHINA / FABRIQUÉ EN CHINE
SERIAL NO./ NUMÉRO DE SÉRIE
,
,
CAN ICES-3(B)/NMB-3(B)
D8
3