Cordless Shaving - Silvercrest SRR 3.7 B2 Operating Instructions Manual

Cordless shaving

CAUTION! MATERIAL DAMAGE!
► This appliance is not suitable for wet shaving!
This shaver can be used without the power cable. In this case, you
must charge the appliance before first use (see section "Charging
the battery").
1) Ensure the cutting unit
2) Remove the protective cap
3) Press the switch lock
the cutting unit
shaver starts.
NOTE
► The best results are achieved if used on dry skin.
► It can take 2 to 3 weeks until the skin is accustomed to the
dry shaving system.
4) Move the shaving heads with straight and circular motions over
the skin.
5) After you covered all the areas you want to shave, set the on/off
switch
the green power light
6) Clean the shaver after every use with the supplied brush
For a more thorough cleaning, read the section "Cleaning and
care".
│ GB │ MT
■ 76
and push the on/off switch
. The green power light
back into its initial position. The appliance stops and
is attached and locked in place.
.
switches off.
towards
lights up and the
.
SRR 3.7 B2