Maintenance; Warranty - Leister EXAMO Series Operating Instructions Manual

Version Tensiometer
EXAMO 300F / EXAMO 300F with USB-Port
EXAMO 600F / EXAMO 600F with USB-Port

Maintenance

• Keep drive shaft (6) clean and grease after 40 hours of operation. When using under difficult environmental con-
ditions, the intervals have to be reduced.
• Keep guide bars (7) (8) clean.
• Friction bearings as well as shaft bearing are maintenance free. Lubrication with grease or oil (with grease addi-
tives such as Zinc Sulphide, Molybdenum Sulphide and similar) is not allowed as this would affect the working life
of the bearings.
• Damaged wiper devices on the sliding carriage (12) have to be replaced immediately.
• Check power supply cord and plug for any possible electrical or mechanical damages.
Service and Repairs
• The carbon brushes in the motor should be checked by your Service Centre after about 1000 hours of operation.
• Repairs have to be carried out by authorised LEISTER Service Centres only. They guarantee a specialized and
reliable repair service within 24 hours using original LEISTER spare parts.

Warranty

• For this tool, we generally provide a warranty of one (1) year from the date of purchase (verified by invoice or
delivery document). Damage that has occurred will be corrected by replacement or repair.
• Additional claims shall be excluded, subject to statutory regulations.
• Damage caused by normal wear, overloading or improper handling is excluded from the guarantee.
• Guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
Conformity
Leister Process Technologies, Galileo-Strasse 10, CH-6056 Kaegiswi/Switzerland confirms that this product,
in the version as brought into circulation through us, fulfils the requirements of the following EC directives.
Directives:
Harmonized Standards
Kaegiswil, 06.04.2009
Disposal
Power tools, accessories and packaging should be sorted for environmental-friendly recycling. Only for EC
countries: Do not dispose of power tools into household waste! According to the European Directive
2002/96 on waste electrical and electronic equipment and its incorporation into national law,
power tools that are no longer suitable for use must be separately collected and sent for recovery
in an environmental-friendly manner.
28
98/37, 2004/108, 2006/95
EN 12100-1, EN 12100-2, EN 60204-1, EN 61326-1, EN 50366, EN 62233,
EN 61000-3-2, EN 61000-3-3, EN 61010-1
Bruno von Wyl
Technical Director
Christiane Leister
Owner