BEFORE USE
▪
Check battery connector is plugged in
▪
Check key is inserted correctly
▪
Check battery charge level
▪
Check brushes/pad holders
▪
Check splashguard
▪
Check squeegee rubbers
▪
Check tanks
▪
Check recovery tank gasket cover
OPERATION
▪
Release the parking brake
▪
Turn key to position 1
▪
Press on/off button
▪
Brushes & vacuum motors will switch on when pedal is pressed
▪
If necessary adjust detergent solution using + & - buttons
▪
Lubricate the splashguard blades by slowly moving back & forth for 1 metre
▪
Do not stop the machine over the same area with brushes spinning (could damage the floor)
▪
If the floor is particularly dirty, use the increased brush pressure function by pressing the button
▪
At the end of each washing operation, lift the brushes, turn the brush switch off and continue with the
squeegee down to complete drying the floor
▪
Lift the squeegee & wait several seconds before switching off the vacuum, this will stop any water
droplets falling onto the floor
AFTER USE
▪
Drain & rinse the tanks
▪
Check brushes/pads
▪
Clean squeegee
▪
Clean mesh filter (in recovery tank)
▪
Clean solution & vacuum filter (weekly)
DO NOT
▪
DO NOT use anything other than low foam detergent in the machine
▪
DO NOT opportune charge (e.g. at tea breaks etc, only charge when the machine is flat)
▪
DO NOT use the machine on an unswept floor
▪
DO NOT use hot water in the machine (cold/lukewarm only)
Eureka E110 Scrubber Dryer
Operator Notice
This notice serves as a quick guide to
important points to remember
The machine should be used by authorised
trained operators only
All operators must read & understand the
operator manual prior to use
Need help?
Do you have a question about the E110 and is the answer not in the manual?
Questions and answers