Acurus Muse Operating Manual And Installer Manual page 44

Direct Volume Level Control:
set of UDP commands that you can directly set
parameters such as the volume level via UDP directly
without restrictions.
For example, to directly change volume, simply change
the two hex bytes highlighted in RED ( byte #9 and #10)
to the HEX value of the number that you wish to set.
Valid volume numbers range from 01 to 99 in increments
of 1.
ASCII UDP COMMAND
06 F9 19 FF 56 4F 4c 30
V66
XML Status Monitoring: When control commands are
issued to the MUSE, quite often, real-time status
feedback is needed by the control system. Real-time
status monitoring can be done by an external control
system by reading the status.xml file available on the
pre-amp processor web server. Many modern 3
control systems have means of reading and parsing xml
files. The XML file can be found at this address on the
pre-amp processor:
FORMAT: http:// IP ADDRESS/status.xml
EXAMPLE: http://192.168.1.245/status.xml
The XML format contains three levels of information: 1)
Identifies the brand, 2) Identifies the model, and 3)
Provides the Type of unit and the Data for the unit.
The example below illustrates the format of the possible
data values for each object in the XML file:
<ACURUS>
<PROD>
<TYPE>TYPE NAME</TYPE>
<DATA1>DATA VALUE 1</DATA1>
<DATA2>DATA VALUE 2</DATA2>
<DATA3>DATA VALUE 3</DATA3>
</PROD>
</ACURUS>
43
Document 1000905
The MUSE also contains a
VOL
LEVEL
36 36 00 00
66
rd
party
...
Acurus MUSE Immersive Processor USER GUIDE
Data types included in the MUSE XML table are listed
below:
MUSE UDP STATUS DATA TYPES:
DATA TYPE
PWR
MUT
VOL
INP
SMD
The following is a complete XML file example for the
MUSE which enables all the above data to be read and
parsed as often as needed by the control system.
<ACURUS>
<MUSE>
<TYPE>PROCESSOR</TYPE>
<XPWR> 1</XPWR>
<XMUT> 0</XMUT>
<XVOL> 14</XVOL>
<XINP> 1</XINP>
<XSMD> 0</XSMD>
</MUSE>
</ACURUS>
DEFINITION
power status
mute status
volume level setting
input selection
sound mode
Revision 20190227