Espresso machine set with electric coffee grinder (8 pages)
Summary of Contents for EspressoWorks All-in-One Barista Series
Page 1
BARISTA SERIES ESPRESSO & CAPPUCCINO MAKER With ELECTRIC COFFEE GRINDER, BARISTA ACCESSORIES, DOUBLE WALLED CAPPUCCINO GLASSES & ESPRESSO CUPS Quick Start Guide Read this booklet thoroughly and save these instructions. FAQs can be found at www.espresso-works.com Email us for any unanswered questions: cs@espresso-works.com FOR PRODUCT REGISTRATION, PLEASE VISIT WWW.ESPRESSO-WORKS.COM...
IMPORTANT SAFEGUARDS INCLUDED IN YOUR PURCHASE WARNING : When using 8. Do not let the cord hang over electrical appliances, basic safety edge of table or counter, or touch hot precautions should always be surfaces. followed, including the following: 9. Do not place on or near a hot gas 1.
INTENDED USE 1. Unpack the items supplied and check them for completeness and transport damage. If the machine or the power cord has damage, do not use the machine, but contact our customer service department at cs@espresso-works.com • This machine is only intended to be used to make specialty coffees using coffee powder and cool milk. 2.
Page 4
POWERING UP YOUR MACHINE PREPARING SINGLE / DOUBLE ESPRESSO STEP 1 INSERT THE DRIP TRAY STEP 2 STEP 3 Place the cover on the drip tray and Place the machine in an open space Open the water tank located at the back slide into the machine as shown.
PREPARING CAPPUCCINO / LATTE MACCHIATO FROTHING THE MILK STEP 1 STEP 2 STEP 3 STEP 1 STEP 2 STEP 3 Fill the water tank with water, tamper Press the release button while pulling Pour milk in the milk reservoir over Fill the water tank with water.
Page 6
PROGRAMMING QUANTITIES TROUBLESHOOTING YOUR MACHINE Both the quantity of espresso and the quantity of milk can be programmed for each function. This allows you to set the perfect Problem Reason Solution quantity of espresso and milk to suit your own taste. The set quantities are saved until a new quantity is set. The control panel does not light up / The power cord is not inserted correctly Insert the power cord.
SAFETY INSTRUCTIONS There is a slight taste of acidity in the Please refer to the Cleaning & The machine was not cleaned and espresso. there are residual coffee grounds. Maintenance chapter on page 17. The machine is equipped with safety features. Nevertheless, The coffee powder has turned bad after Please use fresh coffee powder, or it may still present dangers if it is not used in the intended...
Page 8
head to prevent any accidental, uncontrolled emission of hot milk • Should the machine fall into water, switch off the power supply from the milk nozzle. immediately. Do not attempt to pull it out of the water while it is still connected to the mains power.
CLEANING AND MAINTENANCE • Lay the mains cable in a way that it does not become squashed or bent and does not come into contact with hot surfaces (also applies to the 1. Unplug your espresso machine from the power outlet and allow for it to completely cool off before cleaning. hot surfaces of the machine).
NO EMPLOYEE OR REPRESENTATIVE OF ESPRESSOWORKS IS AUTHORIZED TO MAKE ANY ADDITIONAL WARRANTY OR ANY MODIFICATION TO THIS WARRANTY WHICH MAY BE BINDING UPON ESPRESSOWORKS . ACCORDINGLY, PURCHASER SHOULD NOT RELY UPON ANY ADDITIONAL STATEMENTS MADE BY ANY EMPLOYEE OR REPRESENTATIVE OF ESPRESSOWORKS .
Need help?
Do you have a question about the All-in-One Barista Series and is the answer not in the manual?
Questions and answers