Advertisement
Mounting the
Brush Brackets
Greensmaster Flex Models only
1.
Position the machine on a level surface, engage
the parking brake, remove the key (if equipped),
disconnect the battery, and shut off the machine.
2.
Remove the bolt and washer securing the left
end of the front frame to the tab on top of the
cutting unit
(Figure
1. Bolt
2. Washer
3.
Mount the left brush bracket to the front frame
and tab as follows:
•
On Flex 1800/2100 models, secure the
brush bracket to the front frame and tab with
a flange head bolt (3/8 x 1 inch) as shown in
Figure
2.
•
On Flex 18/21 models, secure the brush
bracket to the front frame and tab with a new
bolt (M10 x 30mm) and the washer that was
previously removed
1).
Figure 1
3. Front frame
(Figure
2).
1. Bolt and washer (Flex
18/21 models)
2. Flange head bolt (Flex
1800/2100 models)
3. Level adjustment screw
Note:
The bracket is to be positioned so the
hole in the bottom is to the front. The bracket
should fit over the end of the front frame and tab.
g018505
4.
Loosely mount the level adjustment screw to the
brush bracket with a jam nut (5/16 inch) and a
locknut (5/16 inch) as shown in
5.
Mount a brush spring and brush rod to the brush
bracket with (2) bolts (M6 x 40 mm), spacers
and locknuts (M6) as shown in
Note:
Ensure that the brush spring is mounted
with the bump to the outside. The brush rod
should be centered in the brush spring when it is
rotated upward, into the storage position.
2
Figure 2
4. Jam nut (5/16 inch)
5. Brush bracket
6. Locknut (5/16 inch)
Figure
2.
Figure
3.
g018486
Advertisement
