Advertisement
1
B
C
D
2
PROBLEM
Condensation occurs when warm moist air inside tent comes in contact with cooler outside air. Avoid touching walls to reduce contact leakage. Venting doors and
1. CONDENSATION
windows will reduce condensation. Store wet clothing outside of tent. A battery powered fan may be helpful. Not applicable to screen houses.
2. SEAM LEAKAGE
Apply a generous amount of seam sealer on inside seams. Seam sealer may be purchased at any local sporting goods store.
To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs, use a soft bristle brush or sponge with mild dishwashing soap or Fels
3. MILDEW
Naptha soap to clean. Let dry thoroughly, and a tent approved water repellent compound may be applied.
4. REPAIRING A TEAR
For small tears, use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.
5. FAULTY ZIPPER
Zippers are self-repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper.
Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.
6. FADING FABRIC
A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain
7. FLOOR CONDENSATION
from running under the tent. Not applicable to screen houses.
Stakes should be installed at a
8. USE OF STAKES
leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.
A
C
B
C
2
angle using a hammer or mallet. Stake loops should be kept taut without over-stretching fabric or webbing. This could cause tears or
45°
SPECIFICATIONS:
1
KEY
NO.
D
Steel Pole - Ridge
A
Steel Pole - Side Pole Middle
B
C
C
Steel Pole - Side Pole End
Steel Pole - Leg
D
3-Way Hub
1
2
3-Way Hub
Rain Fly
Roof Light
Media Pocket
Stakes
TROUBLESHOOTING GUIDE
SOLUTION
12-person
Floor size:
14' x 12' (4.26 x 3.65 m)
Center height:
113''(2.87 m)
Weight:
11.47 lbs (5.20 kg)
REPLACEMENT PARTS
MODEL NO. WT191412AF
DESCRIPTION
PART NO.
HSP19-465rx2,cx2+hubs
HSP19-190r
HSP19-095r,pd,sw
HSP19-365r,sx2+hubs
HHHK15-025-1
HHHK15-155-2
HTFWT191412AF
HRL18'
HTP1210
HMS5-8
QTY.
REQ.
1
2
4
4
2
4
1
2
1
21
WT191412AF 9/18
Advertisement
