Ozark Trail WMT-530NQ, 30660 - Double Size Bed With Mattress Manual

Ozark Trail WMT-530NQ, 30660 - Double Size Bed With Mattress Manual

Also See for WMT-530NQ:

Advertisement

Ozark Trail WMT-530NQ, 30660 - Double Size Bed With Mattress Manual

SET UP BED FRAME

Before you begin

Read all instructions thoroughly before beginning set up.

  • Select a level site clear of rocks, branches and other hard or sharp objects before setting up bed frame.
  • Carefully read all warning tags and TO OPEN /CLOSE VALVE tag on air mattress.
  • Two people can easily setup this bed with air mattress in minutes.

FULLY EXTEND FRAME
as shown in Figures 1, 2 and 3; then flip extended frame over to upright position.
SET UP BED FRAME

AIR MATTRESS PUMP

INSTALL OR CHANGE BATTERIES

  • Unhook latch and open lid to battery compart- ment. (Fig. 4 and 5)
    INSTALL OR CHANGE BATTERIES
  • Insert four D-cell batteries as shown. (Fig. 5)
  • Close lid and hook latch to secure.

INFLATE AIR MATTRESS IN COVER

  • Unfold the mattress and flatten all edges.
  • Put air mattress inside cover
  • Pull valve cap on mattress to open. (Fig. 6)

    NOTE: Insert black one-way valve before filling.
  • Place medium diameter nozzle onto "INFLATE" labeled outlet of air pump. (Fig. 7)
  • Insert filling nozzle into fully opened valve.
  • Switch on air pump and fill mattress to desired firmness. DO NOT OVERFILL.
  • Turn off switch, remove air pump and im- mediately insert valve cap.

ATTACH AIR MATTRESS

INFLATE AIR MATTRESS IN COVER (continued)
NOTE: Make sure air valve on mattress is positioned at the open zippered end of mattress cover. (Fig. 8)
INFLATE AIR MATTRESS IN COVER

Fasteners are located on the bottom side of the cover.

  • Zip up mattress cover completely.

ATTACH MATTRESS TO TOP OF FRAME

  • Align fasteners located on bottom of the mattress cover and top of the bed frame. (Fig. 9)
    ATTACH MATTRESS TO TOP OF FRAME
  • Press down firmly on top of mattress at each corner to secure.

STORING AIR MATTRESS, FRAME & PUMP

  • Remove mattress from frame.

DEFLATE AIR MATTRESS

  • Unzip mattress cover to access valve cap.
  • Pull valve cap to open and pull out the one-way black valve. (Fig. 10)
    DEFLATE AIR MATTRESS

NOTE: This will allow air to escape and start deflating the mattress.

  • Place medium diameter nozzle onto "DEFLATE" labeled outlet on top of the air pump. (Fig. 10)
  • Insert filling attachment into fully opened valve.
  • Turn on air pump switch and remove air until mattress is completely flattened.
  • Remove mattress cover then fold to store.
  • Fold the mattress to store.

FOLD UP FRAME

  • Flip extended frame over to as shown in Figure 3.
  • Fold up legs in reverse order (Figures 2 and 1)
  • Place the frame, mattress and cover in carry case.
  • Remove batteries from air pump and place in carry case.

THINGS YOU SHOULD KNOW

  • Do not leave batteries in the air pump to avoid corrosion.
  • Place a sheet or mattress pad over the mattress cover to help avoid dirt and stains.
  • Remove dirt or stains from the mattress cover with mild detergent and water solution. Dampen cloth in solution and gently rub to loosen dirt and stains.
  • The 3 nozzles that come with the air pump may also be used to inflate a variety of inflatable toys.

Campvalley (Xiamen) Co., Ltd.
No.18th, West Road 3, Jinyuan, Jimei District, Xiamen, Fujian 361022 (China)
Made in China

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Ozark Trail WMT-530NQ, 30660 - Double Size Bed With Mattress Manual

Advertisement

Need help?

Need help?

Do you have a question about the WMT-530NQ and is the answer not in the manual?

Questions and answers

Table of Contents