PMI Chest Roller Instructions

Instructions > PMI Chest Roller Harness
INSPECTION
Inspect Harness before each use. Remove the harness from service and
destroy if it does not pass inspection or if there is any doubt about
the safety or serviceability of the harness. If any of the following
conditions are true, the harness must be discarded:
• If the harness has sustained a signifi cant fall (ie, fall factor 1 or greater).
• If the load bearing components of the harness are damaged in any way.
• If the stitching shows excessive wear, is cut, or is otherwise affected in a
way that might affect harness function or performance.
• If buckles or attachment points do not function properly, or show signs
of excessive wear or damage that might affect harness function or
performance.
• If webbing is not properly rigged, or shows damage or dysfunction that
might affect harness performance.
• If the harness has been visibly damaged by heat, chemical or other
hazardous condition.
• If the harness has been in use for 5 years, regardless of condition.
WARNING
Failure to comply with the instructions and information contained in
this booklet may result in injury or death.
PMI products are warranted to the original retail purchaser to be free from defect in material and workmanship for a period of one year. PMI will repair or replace the item without charge provided
inspection at our factory discloses no misuse or alteration, which, in our judgment, has affected the condition or functioning of the product. All implied warranties imposed by law in connection with the sale
of PMI products are also limited in duration to a period of one year. PMI expressly excludes and shall not be liable for any consequential damages arising out of any breach of the express or implied
warranties on sales of PMI products. Because of the high risks involved in high angle rope work such as, but not limited to, rescue, rope access, caving, rappelling, rock climbing and mountaineering, no further
warranties exist or are implied by PMI. Regulations issued under the Magnuson-Moss Warranty Act require us to include the following statement: some states do not allow limitations on how long an implied
warranty lasts nor the excluding or limitation of incidental or consequential damages, so the above limitations may not apply to you.
A stand alone chest harness for mounting either the single or double
PMI Chest Roller assembly.
Weight: 1.2 lbs (544 g)
MAINTENANCE AND CARE
Proper harness maintenance is essential for maximum performance
and safety.
• Store harness loosely packed in a clean, dry environment.
• A wet harness should be thoroughly dried before storage.
• Do not expose the harness to direct fl ame or high temperature.
• Do not expose the harness to chemicals or damaging substances.
• Harness may be hand washed (gentle) in cool water. Use clear water or a
non-detergent cleanser, and rinse thoroughly.
Inspection criteria should be established by the user according to his
needs, and must consider at least the following hazards:
• Missing or torn components
• Improperly functioning buckles or attachment points
• Webbing and/or stitching that shows excessive wear
• Chemical damage or exposure
• Heat damage
HARNESS FIT
To ensure a good fi t, user must try on and adjust appropriately prior
to use.
• Loosen shoulder straps, and buckles attached to the Chest Roller.
• Place Harness over your head, and slide arms through the shoulder straps.
• Tighten front strap until it is snug around your chest
• Adjust shoulder straps so the height harness is appropriate.
SIZING
Standard
Large
USE GUIDELINES
• Harness should be allocated to a single user.
• Keep harness from contact with harsh chemicals or corrosive substances.
• Avoid excessive abrasion.
• Compatibility with other equipment must be verifi ed by the user.
• Repair or modifi cation of this product without manufacturers consent is
strictly forbidden.
PMI LIMITED WARRANTY
Chest Circumference
30"- 40"
40"- 50"
WEBV1-0411