Beissbarth Start Line MT 601 D Original Instructions Manual page 13

Automatic measurement of distance & diameter
1. Retract the rim-distance gage until the gage head is
close to the inner rim, and hold it there.
2. Whenever the warning tone sounds, return the
rim-distance gage to its starting position.
3. Read out test result from display window.
Fig. 16: Setting gage head for automatic measurement
i
The warning tone confirms the position.
"
Left window shows A value (distance).
"
Right window shows D value (rim diameter).
i
Enter value for rim width manually.
Program layout | Start Line MT 601 D | 33
Manual input of rim data.
1. Pull rim-distance gage onto rim.
2. Read off the scale value.
3. Using the "↑↓" keys, enter the relevant rim data for
A, B and D.
Fig. 17: Reading off scale value A (rim distance)
i
The rim width and rim diameter can also be read off
the rim.
Fig. 18: Measuring the rim diameter
i
The rim width and rim diameter can also be mea-
sured using a measuring compass.
Fig. 19: Measuring the rim width
"
All data required are established and are keyed in.
en
|
1 695 600 538 2016-07-27