NOTE: Read entire instruction sheet before you start installation and assembly. WARNING • Before installing make sure the supporting surface will support the combined load of the equipment and hardware. • Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail. •...
Before you begin, make sure all parts shown are included with your product. Parts may appear slightly different than illustrated. Parts List Description Qty. Part # A ceiling tray 1455-476W B M6 x 10 mm long phillips screw 520-9401 C M6 x 20 mm long phillips screw 520-9402 D hanger bracket 1452-278...
Page 4
Attach four Hanger Brackets (D) to four corners of Ceiling Tray (A) using 10 mm long phillips screws (B). Place Ceiling Tray (A) into 24" (610mm) x 24" (610mm) opening in ceiling (in place of a ceiling tile). Clamp Ceiling Tray (A) to Ceiling Runners using Hanger Bracket Clamps (E) and 20 mm long phillips screws (C).
Page 5
Cut tie wire (G) into four pieces of equal length. Insert wires through ends of turnbuckles. Twist each wire around itself at least four times. Drill holes for four ceiling anchors (see “Various Anchoring Methods"). Position the holes so that when the tie wires (G) when attached and taut will angle out at 15 .