Parts List; Tools Required - Tripp Lite SRCABLETRAY Owner's Manual

Smartrack accessories

1 – Introduction

SRCABLETRAY provides roof-mounted cable routing and power/data cable segregation for Tripp Lite's SmartRack Enclosures.

SRCABLETRAYEXP provides vertical expansion for SRCABLETRAY. (SRCABLETRAY also provides secure mounting points for Tripp

Lite's SRCABLELADDER accessory, sold separately. SRCABLELADDER allows cable bundles to span aisles and/or spaces between

enclosures. See the SRCABLELADDER manual for more information.)

1-1 Parts List

SRCABLETRAY

Trough Section (1)

Support Sections (2)

#8-32 x 1/4 Phillips Screws (8)

M6 Lock Washers (4)

M6 Hex Nuts (2)

24-inch Ground Cable (1)

If anything is missing, call Tripp Lite for assistance at +1.773.869.1234. Note: SRCABLETRAY and SRCABLETRAYEXP are sold separately.

• Phillips Screwdriver

• 13 mm Open-End Wrench or Crescent Wrench (For SRCABLETRAY installation only.)

2 – Important Safety Instructions

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that must be followed during the installation and operation of the products described in this

manual. Read all instructions and warnings thoroughly before attempting installation. Failure to comply may invalidate the warranty and

cause property damage and/or personal injury.

• Install in a controlled indoor environment, away from moisture, temperature extremes, ﬂ ammable liquids and gasses, conductive

contaminants, dust and direct sunlight.

• Provide suitable grounding in accordance with all applicable electrical wiring regulations.

• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life

support equipment or to signiﬁ cantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a

ﬂ ammable anesthetic mixture with air, oxygen or nitrous oxide.

SRCABLETRAYEXP

Expansion Sections (2)

#8-32 x 1/4 Phillips Screws (8)

Srcabletrayexp