Advertisement
3 – SRCABLETRAY Installation
Note: You can remove the roof panel to aid installation, but this step is not required.
Assemble the cable tray by attaching the support sections
1
the trough section
with the included screws. Note: The support
B
sections should be attached inside the fl anges of the trough
section, not outside.
A
B
A
1
Compress the unattached cable tray support section
3
can insert the remaining tabs
slots
. When you release pressure from the cable tray support
F
sections, they will expand to provide a secure fi t.
E
F
3
4 – SRCABLETRAYEXP Installation
Note: You must install SRCABLETRAY before installing SRCABLETRAYEXP. SRCABLETRAYEXP includes two expansion sections; you may
install one or both, depending on your needs.
4-1 One Expansion Section
Attach the expansion section
1
included screws.
A
until you
A
into the matching roof panel
E
E
F
to the cable tray
with the
A
B
to
Insert the tabs
at one side of the cable tray into the matching
2
C
roof panel slots
D
you to adjust the cable tray's position to match your preference.)
C
D
2
Use the included hex nut
4
end of the included ground cable
the corner of the cable tray. Connect the other end of the ground
cable to the metal frame of the rack enclosure. (Follow the ground
wires connected to the rack enclosure's doors to locate several
convenient ground connection points on the frame.)
G
J
H
I
4
A
B
1
3
. (Several sets of slots are compatible, allowing
D
and lock washers
G
H
to a grounding post
I
H
C
to connect one
at
J
TO
Advertisement
