Installation Within Row - Tripp Lite SmartRack SRCABLELADDER Owner's Manual

3 – Installation
(continued)

3-5 Installation Within Row

Note: Follow the instructions in this section only if the SRCABLELADDER accessory will be installed within a row of enclosures. If the
SRCABLELADDER accessory will be installed across an aisle, follow the instructions in Section 3-4 Installation Across Aisle instead.
1 Insert four assembly brackets
hooked end first. When the ladder is oriented so that the ladder's
rungs are above the ladder's side rails, the hooked ends of the
brackets should point down, as shown in the drawing.
Align the pin holes in the ladder sections with the pin holes
2
in the assembly brackets and insert clevis pins
holes (4 total). This step may be omitted to provide additional
installation flexibility, but installing the pins will make the
SRCABLELADDER accessory more stable. Warning: If you
choose not to install the clevis pins, make sure at least 25% of
the length of each assembly bracket is inside the ladder.
After inserting the clevis pins, insert a cotter pin
3
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)
Using an assistant, lift the SRCABLELADDER accessory (rungs
4
upward) and align the holes at the ends of the assembly brackets
with the corresponding holes
D
accessories installed at the top of each enclosure. Note: There are
two levels of holes. Use the holes that match your application best.
Align the pin holes and insert clevis pins
5
holes (4 total).
in the open ends of the ladder,
A
into the pin
B
through the
C
in the SRCABLETRAY
E
into each of the pin
F
A
1
B
2
C
3
D
4
F
5
6
B
E