Things To Know - Sequence Code Definitions For The E2600 Controller-Drive Tray; Things To Know - Lock-Down Codes For The E2600 Controller-Drive Tray - Bosch DSA E Series Installation Manual

82 en | Turning on the Power and Checking for Problems
11.7 Things to Know – Sequence Code Definitions for the E2600
Controller-Drive Tray
During normal operation, the tray ID display on each controller canister displays the
controller-drive tray ID. The Diagnostic LED (lower-digit decimal point) comes on when the
display is used for diagnostic codes and goes off when the display is used to show the tray ID.
Table 11.14 Sequence Code Definitions for the E2600 Controller-Drive Tray
Category
Startup error
Operational error
Operational state
Component failure
Diagnostic failure
Category delimiter
End-of-sequence
delimiter
Notes:
1 A two-digit code that starts a dynamic display sequence.
2 A two-digit code that follows the category code with more specific information.
3 The plus (+) sign indicates that a two-digit code displays with the Diagnostic LED on.
4 No codes display, and the Diagnostic LED is off.
11.8 Things to Know – Lock-Down Codes for the E2600 Controller-
Drive Tray
Use the following table to determine the diagnostic lock-down code definitions on the Seven-
Segment Display in the controller canister for the E2600 controller-drive tray.
Table 11.15 Supported Diagnostic Lock-Down Codes on the Seven-Segment Display
Diagnostic Code
– –
.8, 8., or 88
- | V2 | 2012.09
Category Code (See Detail Codes (See Note 2)
Note 1)
SE+ (See Note 3) –
–
OE+ Lx+ Lock-down codes. (See
Section 11.8 Things to Know – Lock-Down
Codes for the E2600 Controller-Drive Tray,
page 82.)
OS+ –
–
–
CF+ –
–
–
–
–
dE+ Lx+ = Lock-down code.
dash+ The separator between category-detail code
pairs is used when more than one category
detail code pair exists in the sequence.
Blank (See Note 4) The end-of-sequence delimiter is automatically
inserted by the hardware at the end of a code
sequence.
Description
The firmware is booting.
This ESM is being held in reset by another ESM.
Installation Manual
E2600 DSA E-Series iSCSI Disk Arrays
88+ Power-on default.
dF+ Power-on diagnostic fault.
OL+ = Offline.
bb+ = Battery backup (operating on
batteries).
Cf+ = Component failure.
dx+ = Processor or cache DIMM.
Cx = Cache DIMM.
Px+ = Processor DIMM.
Hx+ = Host interface card.
Fx+ = Flash drive.
Bosch Security Systems