Replacing The Optical Drive - Lenovo V130–20IGM AIO User Manual And Hardware Maintenance Manual

Figure 18. Installing the tilt-only monitor stand
Figure 19. Installing the tilt-only monitor stand screws
6. Complete the replacement. See "Completing the parts replacement" on page 49.

Replacing the optical drive

Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the computer cover is against the surface and the screen is facing up.
3. Remove the tilt-only monitor stand base. See "Replacing the tilt-only monitor stand base" on page 17.
4. Remove the front cover. See "Removing the front cover" on page 17.
5. Remove the tilt-only monitor stand. See "Replacing the tilt-only monitor stand" on page 19.
20
V130–20IGM AIO User Guide and Hardware Maintenance Manual