Standby And Hibernate, Shut Down And Restart; Inferred Modes - NexxTech 1511217 User Manual

Standby and Hibernate, Shut Down and Restart

When the adapter is connected to a computer and an external monitor, if the computer goes into
standby or hibernate mode, the external monitor display goes blank.
When the computer returns to an active state, the external monitor display keeps the same settings it
had before the computer went into standby or hibernate mode. However, if the secondary monitor was
set for extended mode, windows that were previously on the external monitor will not move back to that
secondary monitor. Also, if the secondary monitor is in extended mode and the computer requires a
login after standby or hibernate mode, the login screen appears on the primary computer monitor, not
the external monitor.
If the computer is shut down, restarted and logged in again the secondary monitor returns to the same
mode as it was before shutdown.

Inferred Modes

Some modes in the DisplayLink menu are shown with square brackets [ ] around them.
This occurs when connecting a monitor with a preferred mode higher than the maximum supported
resolution of the DisplayLink device.
In this case, the preferred resolution of the monitor cannot be supported. However, we add lower
resolutions of the same aspect ratio to be tried with the monitor. Modes in square brackets [ ] imply
that these are modes not reported by the monitor, but have been made available by the DisplayLink
software for you to try .
As these are inferred modes from the preferred mode of the monitor, they are not guaranteed to work
with the display.
23