Related Manuals for Intrepid Control Systems NeoVI PLASMA
Summary of Contents for Intrepid Control Systems NeoVI PLASMA
- Page 1 Intrepid Control Systems, Inc. Plasma/ION Cellular network setting checkpoints Document Number: AN-ICSI-1009 Rev 2.0 08/2014...
-
Page 2: Table Of Contents
To verify SIM card working status: ................. 3 Plasma/ION Accessories setting: ..................4 To access screen for ION: ....................5 Check for cellular signal: ....................7 Check for data setting:...................... 8 Contact Us: ..........................9 Page 2 © Copyright 1997-2014 Intrepid Control Systems, Inc... -
Page 3: Introduction
SIM with 3G data enabled. Normally device is taking all setting automatically. The neoVI Plasma/ ION Cellular network setting is same as android based mobile setting. This document is useful to check cellular SIM card setting if device is not able to enable 3G data automatically. -
Page 4: Plasma/Ion Accessories Setting
AN-ICSI-1009 2.3 Plasma/ION Accessories setting: Insert SIM in correct manner in SIM slot of neoVI Plasma/ION. To insert the SIM card (while looking at the front of Plasma), insert SIM card squared side first with its notch facing outboard. Card contacts will be face down towards the pinout label. -
Page 5: To Access Screen For Ion
Connect ION to monitor or projector using HDMI connector on ION. It will display screen on monitor as shown in Figure 3 Figure 3: Plasma/ION home screen Connect mouse and keyboard to ION’s USB port using USB connector to access control. Page 5 © Copyright 1997-2014 Intrepid Control Systems, Inc... - Page 6 Open Vehicle Spy3.Go in tool ON/plasma setup. It will create VNC connection and display the ION/plasma screen on monitor(Figure 4) Figure 4: Plasma/ION home screen NOTE: Both the options mentioned above are also applicable for Plasma. Page 6 © Copyright 1997-2014 Intrepid Control Systems, Inc...
-
Page 7: Check For Cellular Signal
It will search for operators and shows the list of available operators. Then select ‘Select automatically’ option so it will connect automatically to right operator. Then check for signal strength. Figure 5: Plasma/ION home screen Page 7 © Copyright 1997-2014 Intrepid Control Systems, Inc... -
Page 8: Check For Data Setting
After finishing above setting it should enable cellular data and it will shows 3G or 2G data symbol on right side top of screen as shown in (Figure. 6 (1)) Figure 6: Plasma/ION home screen Page 8 © Copyright 1997-2014 Intrepid Control Systems, Inc... -
Page 9: Contact Us
AN-ICSI-1009 Contact Us: Intrepid Control Systems, Inc. Email: icsindia@intrepidcs.com Website: www.intrepidcs.com Page 9 © Copyright 1997-2014 Intrepid Control Systems, Inc...
Need help?
Do you have a question about the NeoVI PLASMA and is the answer not in the manual?
Questions and answers